1964–1965 Pontiac GTO A/C Dual 14-Inch Fan Shroud | Cold Case GPG22

Dual 14-Inch Fan Shroud for 1964–1965 Pontiac GTO with A/C | Cold Case GPG22

Build your Pontiac's dual electric fan setup around a shroud designed for the Cold Case GPG22 radiator in 1964–1965 Pontiac GTOs with air conditioning. Custom designed by Monty and manufactured by SendCutSend, this three-piece shroud accommodates the compatible 14-inch fans listed below.

Compatible Radiator Models & Clearance

• Designed for Cold Case GPG22 radiator variants in 1964–1965 Pontiac GTOs with A/C.
• Also fits GPG38 radiators, as noted in this listing's fitment information.
• Three-piece construction for a down-flow radiator layout.
• Check clearance before ordering: the fan mounting surface sits 0.980 inches from the radiator core's finned area. Review the detailed drawing and allow room for your selected fans and engine accessories.

Need fans too? Save around 5% on the entire kit. Shroud & Fan Kit Builder — Build your kit here.

Fan Compatibility

• SPAL 30102042: 14-inch puller fan, listed airflow of 1,864 CFM per fan. Buy here
  • SPAL 2-pin AMP jumper harness FR-PT-PKG. Buy here
• Proform 67035: 14-inch brushless fan with Soft Start.

Compare real-world fan performance in Monty's independent fan CFM test results.

Finish Options

• Matte Black: stocked finish and the lowest-cost powder-coated option. Includes twelve M6x1 fasteners. If shown out of stock, placing an order triggers the next batch order.
• Raw Aluminum: made to order. Witness marks near the bends can often be cleaned with a Magic Eraser. Scuff the entire surface with Red Scotch Brite for a uniform appearance, or paint to suit your build.
• Custom Color: made to order using the pictured color card. Monty will email after your order to confirm your color choice.

What's Included / Not Included

• Fan shroud.
• Matte Black only: twelve M6x1 fasteners included.
• Other finishes: fans, flap doors, and fasteners are not included.
• Required flap doors: two SPAL 30130012 rubber flap doors. Buy here
• Fastener specification: M6x1, 16mm long.

Installation Details

• Twelve M6x1 threaded holes: eight for the fans and four for the side brackets.
• The existing installation recommendation specifies M4x1 RivNuts in the radiator side braces for mounting the brackets.
• Do not drill deeper than 3/8 inch through the side plates. Review the instructional video before installation.

See our Radiator Fan Shroud Installation Guide for step-by-step instructions.

Shipping & Lead Times

• Raw Aluminum: approximately one week to ship.
• Powder Coated: approximately two weeks to ship.
• Raw aluminum and powder-coated made-to-order shrouds are drop shipped directly from SendCutSend.

All drop shipped sales are final.

Looking for a deal? Check Monty's Discounted Parts & Blems for working shrouds with minor cosmetic blemishes.